Solar installers

Industry partnersSolar installers

Installing the right hardware and configuring it correctly allows customers to get the most from their solar systems. This page explains the connection process, lists hardware approved to be connected to our network, and shows how installations can comply with the Victorian Government’s emergency backstop requirements.

Emergency backstop information

Approved inverters list

Model Standing Offer (MSO)

eConnect help

Steps to connection

All new, upgrading and replacement rooftop solar systems with 200kVA of capacity or less must be emergency backstop enabled. To be emergency backstop enabled, a solar system must be able to communicate using the Common Smart Inverter Profile Australia (CSIP-AUS) technology protocol and be connected to the internet.

Before you go

Presale

Consult with the customer regarding their requirements and explain the solar installation process.
Check the Clean Energy Council website for approved CSIP-AUS ready inverters and software communication clients.
Check our list of onboarded inverters.
Confirm the customer has a reliable internet connection.

Application and offer

Check with the manufacturer to make sure you have the required hardware for the installation, including an export limiting meter.
Submit a pre-approval application via eConnect and ensure it’s in an approved and valid state before attending the site.
Advise customer of the outcome.

While on site

Install

Install an approved CSIP-AUS solar inverter and export limiting meter as per the manufacturer’s installation guide.
Ensure the device has the latest firmware. Check the inverter is set to Region A settings AS4777.2.2020 .
Configure the inverter and associated equipment to the customer’s internet.

Register

Register the customer’s solar inverter via the manufacturer’s app.
Create and verify a Long Form Device Identifier (LFDI) for the inverter.
Confirm successful registration with CitiPower or Powercor.

Test and close out

Test

Ensure the system is generating at least 500W before starting the test.
Initiate the capability test (takes about 10 minutes).
Confirm capability test is successful.

Close out

Arrange for a Licensed Electrical Inspector (LEI) to inspect and approve the installation.
Submit the alteration in eConnect and attach the Certificate of Electrical Safety (CoES).
After the solar alteration request has been completed and paperwork validated by CitiPower/Powercor, the DER will be registered and confirmed. Only then will the approved export limit be activated.

Support and assistance

Our New Energy Services team are the first point of contact for solar installers.

Contact them at newenergyservices@powercor.com.au or on 1800 772 940 (8am-4pm, Monday to Friday).

Downloads

Solar pre-approval resources

Detailed guides on how to submit pre-approval requests to connect rooftop solar to the network via eConnect.

CitiPower only documents

Powercor only documents

Looking for something else in
Industry partners

Explore another page

CitiPower and Powercor acknowledge and respect the Traditional Owners as the original custodians of the lands and waters where we operate. We recognise First Peoples’ unique rights as Traditional Owners and their deep spiritual connection to Country, and thank them for continuing to care for it. We honour Elders past and present whose knowledge and wisdom has ensured the continuation of culture and traditional practices.

We work hard to ensure our organisation is inclusive and diverse. This means everyone can feel valued, trusted, authentic and safe at work.